Appendix B: Grayloc Calculations

  • 3 Articles
Prev Next
SMX Torque Lookup
  • Published on Jan 30, 2025
The user must specify the Clamp Size . IMS then uses a lookup table (see below) to determine the (default) Stud Size , (default) Wrench Size , and the Torque values. Grayloc Torque:
Flange Thickness Measurements Lookup - Hubs
  • Published on Jan 30, 2025
The user can specify the Hub size , however IMS uses the Clamp Size as a default. From this IMS determines the HC , Seal Ring Range min , Seal Ring Range max , Reading over 1/8 Balls , Reading over 1/4 Balls , and Tolerance . Flange Thickn...
Stand Off Range Lookup
  • Published on Jan 30, 2025
The user can specify the Seal Ring size . From this IMS determines the Stand Off Range . Stand Off Range: