Creating Flanges: Flange-FLOC & Equipment

This Section of the Handbook describes the process of creating Flange FLOCs and Equipment in FCM It should be noted that non-Flange FLOCs and Equipment, or Level 4 items, are visible in FCM but they cannot be created in FCM. For example, to creat...

The FLOC details page contains 6 sections (see figure below): Details – general information about the FLOC. Hierarchy – Flanges connected to the FLOC and its Equipment. From here you can create new Flange-FLOCs (click on the Flange tab). ...

Flange-FLOCs can be created in two ways: Single Creation (user interface); or Multiple Creation (import wizard – bulk upload). See below. Creating Individual Flange-FLOCs There are several places in the user interface from where you c...

The Flange-FLOC details page contains 6 sections: Details – general information about the Flange-FLOC. Hierarchy - From here you can create new Flange or Grayloc Equipment . Jobs – list of Jobs (to be) performed on this Flange-FLOC. From here n...

In FCM, only Equipment of type Flange and type Grayloc can be created. To create other types of equipment, you must switch to the IMS PEI module. For sites interfaced with SAP, these other Equipment types must be created in SAP. Creating Flange Equ...

FCM Equipment Details Equipment (Level 4) that is available in IMS PEI is visible and can be used to establish relationships with Flange-FLOCS (Level 5), and Flange and Grayloc Equipment in FCM. The FCM Equipment Details (Level 4) Page differs ...

The Flange Equipment details page contains 9 sections: Details – general information about Flange Equipment. Flange Design – the Design tab contains the input fields for the 3 different Flange calculations (including Tightening data and Recomm...

Once you have created or imported your Flange FLOCs, you can assign design parameters for each of the Flanges. This can be completed from the Flange Design section of the Flange’s Details page. To define a Flange’s design: Go to the Flange Equip...

The Grayloc Equipment details page contains 9 sections: Details – general information about Flange Equipment. Grayloc Design – the Design section can be used to enter the Tightening data and Recommended Spec. The calculated Torque Values are also...

To do a Grayloc design: Go to the Grayloc Equipment Details page. Scroll to the Grayloc Design section. Click Edit . In the Design section – specify the design input: Tightening Step 1 Clamp Size - used to determine Torque . See ...