PEI Circuits

This online manual explains the Corrosion Circuits in IMS: How to interpret and use the Circuits Main screen (list). How to create new Circuits. How to create and manage Measurement Sets. How to interpret the Circuits Details Page in ...

The Circuits Main screen shows an overview grid, with a list of Circuits. Listing Circuits (the Overview Grid) To see the list of registered Circuits: Go to the IMS Main Menu. Click Circuits to go to the Circuits main screen. Click on...

There are several places in the application from where you can add a new Circuit, for example: To create a Circuit: Click + to create a new Circuit. Enter the required data in the pop-up window. See the table below. Click Save when done. ...

To open a Circuit Details Page, click on the desired Circuit ID hyperlink in the Circuit main screen (or on any other screen). See IMS Details Page . The Circuit Details Page can be divided into sections: Header The header of the detail page sho...

This section of the Handbook explains how to create and manage Measurements Sets in IMS. Measurement sets (MSET) are used to record wall thickness data measurements associated with a CML in IMS. The measured wall thicknesses are then used in I...

At times it occurs that Corrosion calculation encounters problems due to a large number of time/growth errors and warnings. This situation is directly proportional to the quality of inputted readings. Use case The below example demonstrates a case...

Under specific conditions, IMS can recommend minimum Renewal Thickness. Suggestions are provided to the Inspector so that in these specific conditions an optimal Renewal Thickness may be selected. It is left to the inspector to determine whether ...