Special Emphasis Configuration
- 09 Aug 2024
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Special Emphasis Configuration
- Updated on 09 Aug 2024
- 1 Minute to read
- Contributors
- Print
- DarkLight
- PDF
Article summary
Did you find this summary helpful?
Thank you for your feedback
The available Special Emphasis types are defined in Settings. For each type, inspection intervals are configured. Your CSA can add or change this data.
Special Emphasis Types
For each Special Emphasis Equipment, different classes can be defined. This configuration is done in Settings \ Maintenance \ Inspection/Schedules \ Special Emphasis.
Special Emphasis classes are defined in settings.This configuration is done per site. The table below shows the Special Emphasis types typically available. The full list of available (and non-expired) Special Emphasis types can be found in the Settings (see the figure above).
Special Emphasis types:
Category | Special Emphasis |
|---|---|
Injection Points | IP: CLASS. A (12 MO. MAX) |
IP: CLASS. B (36 MO. MAX) | |
IP: CLASS. C (36 MO. MAX) | |
IP: CLASS. D (72 MO. MAX) | |
IP: CLASS. E (120 MO. MAX) | |
IP: CLASS. E (96 MO. MAX) | |
IP: CLASS. F (NO MAX) | |
Corrosive Deadleg | DL: CLASS. A (12 MO. MAX) |
DL: CLASS. B (24 MO. MAX) | |
DL: CLASS. C (36 MO. MAX) | |
Unstable Deadleg | Unstable: CLASS. A (12 MO. MAX) |
Unstable: CLASS. B (36 MO. MAX) | |
Unstable: CLASS. C (36 MO. MAX) | |
Soil to Air | SOIL TO AIR |
Configuration of Max interval and Default interval
For each Special Emphasis Type, a Default interval, as well as a Max interval, is configured in Settings \ Maintenance \ Configuration \ Configuration per Hierarchy Type.
A Special Emphasis is configured per:
- FLOC Type,
- Equipment Type, and
- Schedule Type.
For each of the above combinations a Default interval, as well as a Max interval, is set. This will impact the interval on the Corrosion / Inspection Schedule. The below figure gives an example of an Injection Point (IP) configuration for a PIPE-FLOCs.
Special Emphasis (IP) configuration for PIPE-FLOCs.
Was this helpful? Click to add feedback comments