--- title: "Load Case Calculation Overview" slug: "load-case-calculation-overview" updated: 2026-03-09T10:15:49Z published: 2026-03-09T11:26:46Z canonical: "ims-handbook.cenosco.com/load-case-calculation-overview" --- > ## Documentation Index > Fetch the complete documentation index at: https://ims-handbook.cenosco.com/llms.txt > Use this file to discover all available pages before exploring further. # Load Case Calculation Overview Below we show the summary of the Load Cases Calculations for Welded tanks. You will find more information on the calculations in the following articles. | | Load Case 1 | Load Case 2 | Load Case 3 | | --- | --- | --- | --- | | **Description** | Shell calculated wall thickness | Buckling Calculation (wind) | Roof Pressure (on the Shell) | | **Objective** | Calculate the RL based on corrosion | Calculate the number of Wind Girders needed for the Course and the RL | Calculate the impact on RL of Roof pressure on the tank Shell. | | **General RBI Specs** ****General Component Data** ***EQUIP SPECIFICATIONS** ****COMPONENT SPECS** **Other specifications might be required, depending on material, DM, Component** | Compliance Code (e.g. DEP, API) Pitting (checked=yes) Joint Efficiency Factor** (if not specified, default derived from SRBI-SHELL JOINT TYPE*) Thickness as built** For Courses: Course Height** Yield** Tensile strength** MAXIMUM FILL HEIGHT* SRBI-DIAMETER* SPEC GRAVITY @ OP TEMP* DESIGN PRESS* For Roof and Floor: RENEWAL THICKNESS** | Compliance Code SRBI-MAX OPERATING TEMPERATURE* SRBI-WINDSPEED* SRBI-DESIGN VACUUM* AND the LCI Calculations | Course Height** (top Course) SRBI-DIAMETER* | | **Output** | RL (used for NID) Product Height** Minimum Allowable Wall Thickness** | Number of Girders required (optional) RL (for reference only) | RL (for reference only) | | **Where to find it** | RBI Analysis – **Calculator** Tab | Menu bar on Equipment Level | Menu bar on Equipment Level | | **Notes \| Recommended Approach** | For first calculation, need to provide data for at least one inspection (with current wall thickness) | For a proper calculation of buckling, all Courses must be added. | If RL is lower than LC1, additional measures must be taken to assure integrity. | | **Exceptions** | LC1, LC2, and LC3 are not applicable to riveted Shells. |