PEI Circuits

Prev Next
  • Updated on Sep 2, 2026
  • Published on Mar 9, 2026
This online manual explains the Corrosion Circuits in IMS: How to interpret and use the Circuits Main screen (list). How to create new Circuits. How to create and manage Measurement Sets. How to interpret the Circuits Details Page in ...
  • Published on Mar 9, 2026
The Circuits Main screen shows an overview grid, with a list of Circuits. Listing Circuits (the Overview Grid) To see the list of registered Circuits: Go to the IMS Main Menu. Click Circuits to go to the Circuits main screen. Cl...
  • Published on Mar 9, 2026
There are several places in the application from where you can add a new Circuit, for example: To create a Circuit: Click + to create a new Circuit. Enter the required data in the pop-up window. See the table below. Click Save when done. ...
  • Updated on Sep 2, 2026
  • Published on Mar 9, 2026
To open a Circuit Details Page, click on the desired Circuit ID hyperlink in the Circuit main screen (or on any other screen). See IMS Details Page . The Circuit Details Page can be divided into sections: Header The header of the detail page sho...
  • Updated on Sep 2, 2026
  • Published on Mar 9, 2026
This section of the Handbook explains how to create and manage Measurements Sets in IMS. Measurement sets (MSET) are used to record wall thickness data measurements associated with a CML in IMS. It is important to keep in mind regarding MSETs: ...
  • Published on Mar 9, 2026
At times it occurs that Corrosion calculation encounters problems due to a large number of time/growth errors and warnings. This situation is directly proportional to the quality of inputted readings. Use case The below example demonstrates a case...
  • Updated on Mar 27, 2026
  • Published on Mar 9, 2026
Under specific conditions, IMS can recommend minimum Renewal Thickness for a CML . Suggestions are provided to the Inspector so that in these specific conditions an optimal Renewal Thickness may be selected. It is left to the Corrosion Engineer ...
  • Published on Mar 9, 2026
This article provides a step-by-step example from creating a Circuit, to creating the CMLs, to creating the Measurement Points, to adding the measurement data, all via bulk import. In the example we will import data for a Vessel Equipment. Creating...