PEI Creating New CMLs

There are several places in IMS from where you can create a new CML. For example;

Section	Screenshot
CML main grid (Header bar)
Circuit main grid (Side info bar)
Circuit details (CML Tab)

Section

Screenshot

CML main grid

(Header bar)

Circuit main grid

(Side info bar)

Circuit details

(CML Tab)

To create a CML:

Click Plus to create a new CML.
Enter the required data in the pop-up window. See the table below.
Click Save when done.

The new CML will be created and you will be redirected to its Details page. Note: You can open a CML Details Page at any time by clicking on the hyperlink in the CML column on the CML tab in the Circuit Details Page.

CML Popup fields:

Field /Column	Description
Circuit	The name of the Circuit that the CML is part of.
Sub Circuit	Sub-Group of the Circuit, for grouping similar CMLs within a Sub-Circuit. The Sub-Circuit-CML combination should be unique. If you do not want to group CMLs, you can use this as a short description. It is a mandatory field.
CML	The CML ID, click on it to open the CML Details Page. The Active flag shows for each Circuit whether it is active or inactive: Active Circuit Inactive Circuit
CML Description	Short Description for the selected CML.
CML Type	Type of CML (e.g., PIPE, HEADER BOX, REDUCER, TEE, SHELL, CHANNEL, NOZZLE).
Must get	Check if this CML must always be measured.
Position	Position of the CML in the Circuit.
Nominal WT	Nominal Wall Thickness for the CML.
Diameter	Nominal Diameter fro the CML.
Renewal Thickness	Minimum Wall Thickness (WT) for the selected CML.
Renewal Basis	Renewal basis, either CALCULATED, FITNESS FOR SERVICE, NOMINAL MINUS CORR ALLOWANCE, STRUCTURAL MIN.
Required Inspection Method	Option to set a required Inspection Method (e.g. UT, RT) for all measurements for the CML (optional).
Design Corrosion Allowance	Design Corrosion Allowance
Drawing Filename	Name of the related drawing file.
Line number on drawing	Line number on drawing.
Line number in P&ID	Line number in P&ID.
Sketch number	Sketch number.
Longitude	Longitude
Latitude	Latitude
Altitude	Altitude

The data you entered while creating a new CML will be displayed on the CML Details Page.