The MiRO Equipment are aligned with the standard IMS Equipment, except that:
- The Equipment Inspection Reasons are aligned with the German regulation "BetrSichV. Take not that the Inspection Reason is inherited from the FLOC.
- For Pipe Equipment, the Product can be defined. This influence Corrosion Rate Confidence Target in M-IDAP.
- Equipment can be connected and pinned. See Connecting MiRO Equipment.
- For Equipment with Connected Circuits and Measurement Sets (MSETs) these MSETs are shown in a MSET section on the Equipment Details Page.
- Pipe Equipment contain specific Piping Specifications only applicable to MiRO. These are inherited from the FLOC. The Max Temp & Max Pres are used in the Piping Class Compliance check.
.png?sv=2026-02-06&spr=https&st=2026-10-28T13%3A35%3A26Z&se=2026-10-28T13%3A46%3A26Z&sr=c&sp=r&sig=8xa7XIcUbVilELetPXjsKbU2rFYgxxI%2FSSRJWihUUFc%3D)
The MSET and Specs section on the Equipment Details Page. Specifying the Product
To specify the Product for a Pipe Equipment:
- Go to the Equipment Details Page.
- Click on Edit.
- Select a Product.
The Product can be selected on the Details Page. - Click Save.
Standard PEI Instructions
To learn more about Equipment see PEI Equipment.
To learn more about Specifications see IMS Details Page.
To learn more about Specifications see IMS Details Page.