S-IDAP TrendPlots

The Trendplots are are shown in the bottom of View 1 (opening screen) / View 2.

Number of Plots

The number of Trendplots displayed depends on the number of rows visible in the Results tab or Measurements tab. For example, if the number of rows is set to 25, then 25 Trendplots will be displayed.

Adjusting Y-Axis

You can specify the minimum (Min WT) and maximum (Max WT) values for the y-axis on the left side of the Trendplots. This feature is useful for comparing data from piping with the same diameter and Nominal Wall Thickness.

Verifying Reading

A reading can be set to Good, Verified or Ignored by pressing the right mouse on a reading in the TrendPlot. You can also select “Mitigation” (to create a CAIR) or add Notes or an Attachment.

If readings have been set to “Ignore” or “Verified” you have to click Save to start the re-calculation.

To learn more about reviewing and verifying error reading see Data Quality (Identifying Anomalies).

CR shown

The Maximum Corrosion Rate is shown as Cri in the title bar of the plot.